So the surge ring ended up being pretty complicated. It was hard to attach the Surge ring to the main body. I tried to make supports, but they were too flimsy so they didn't work. Then I decided to make put a piece of cardstock on the body, and then fit the surge ring on that. I hope it works. 

In the beginning, I was going to make plates on the front and back. But it was hard to do that, so my parents ended up buying some foam caps to put on each side. But then the body of the spaceship was too big for the caps, so I ended up cutting off a chunk of the body. But then it was too small, so then I put the cap in and put tape on to cover-up the opening 

I am finally finished with my project. It was very hard to get to where I am. There were many struggles but I am pretty glad with my final outcome. I really enjoyed the project and it was a ton of fun.

My final presentation is in the squash courts and ready to go for tomorrow's presentation.

I finished the sanding of the sword. 

Finished the outline and coloring during middle makers

The heat press ready to stick the Vinyl to the shirt

The vinyl being cut

Vinyl