This is the handle after being laser cut.

I glued the handle together and spray painted.

These are the tinfoil blades I cut out and laminated.

then attached the tinfoil blades to the handle.

This is my printed out 3D arrow head (for the god Brahma)

I then painted it red-ish maroon because it was the color of the god Brahma.

I realized that it wasn't an arrowhead but a diamond, so this is my design for the diamond.

This is my printed out 3D diamond (for the god Brahma)

I then painted it red-ish maroon because it was the color of the god Brahma.

This is my 3D design of the Kali Aastra on Tinkercad.

This is the Kali Aastra after being 3D printed.

I then painted it blue/black because that was the color that represented Kali. (I also chipped off the top because in the book, part of it enters Ash Mistry's bloodstream which gives him powers.

These are my laser cut pieces (they are little too big, so I am planning to saw or sand them down).

This is the Katar (punch dagger) after being glued together, shortened, and sanded.

I shortened the dagger and adjusted the handle

This is the final version of the Katar after being painted.

This is my bow after I added rubber string through the holes and hot glued the laser cut together.

I used yellow and silver for the spray paint because thee gold spray paint was broken. I also added an arrow and painted it.