Today I made a laser cut file for a display for my hammer. This will be laser cut and then painted with a matte black

Today i added the handle of the hammer and two pieces on either end of it. I haven't finished, but I am doing a spiral pattern around the section that will be used as the grip.

Today I Put Together the pieces that I had spray painted and stained the day prior. I also glued and screwed together the hammer head and handle.

Aegis-Fang

One Hammer to Rule Them All

By Eli Herrick

Today I added the other side of head and continued to sand it and smooth out the sides. I am preparing it to be painted and the handle, to be stained

Today I put together my hammer. I hot-glued the center piece and one of the tapered side pieces. I then sanded down a edges that were poking out of the surface

Today I was able to Laser cut the Head of the Hammer from Cuttle. I haven't been able to do anything with it yet but that will be my next step

Today I created an SVG on cuttle for the head of my Warhammer. In added all the measure ments and a piece to hold the handle in place.

Today I worked on a sketch of my project, the Warhammer. I labeled it and got it approved with Ms.Cook